![]() They said if I remove them and install the full flow aerators that they sent in a bag, that it will then flow however much water my plumbing system puts out. So I called the fill drain manufacturer and they told me the drain comes with aerators installed. I want to make sure it performs well and they don't have to wait forever for it to fill.ĭo you recommend I consider something other than the combination drain and fill? This tub is in a bed and breakfast so it will be used by guests. I've not installed any of this yet so if I need to change directions now is the time to do it. Then 1/2" from the valve to a Tee where the other valve would tie in and then a single 1/2 pex to the filler. The 3/4" supply lines would be reduced to 1/2" going to the valve. I was opting for pex as an easier install. I cannot mount the valves on the tub deck (which is already tiled) So basically, around the corner from the valves. You can see that in the bottom center of the photo. Then I have to run piping from the valves to the long side of the tub where the combination drain and filler is located. In the photo above, they would be located on the right side where the hump sticks out. I have to drill holes and mount the valves on the short end of the tub. I have 3/4 pex run right to the framing where the tub will sit.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |